|
|
|
|
Specific Search Results Below:
|
| |
|
HGEN
|
| |
Sheldon Imaoka (ANSYS, Inc.)
|
| |
When using spatially-varying tabular loads for heat generation rate, a common mistake is to specify the table name only for VAL1 in the BFE command. If this is done, subsequent values will use the same value as VAL1, giving constant heat generation rate per element.
Instead, each node should be given its own value with the BFE command by specifying the table name in all values. This is a simple example demonstrating this.
(This issue does not exist if using spatially-varying tables with the BF command since the BF command is directly specifying heat generation rate per node.)
[permalink]
|
| |
|
Average Rating: 10.0 (5 votes)
|
|
|
| |
|
|